开云体育

Set the BFO to 11.9965 and see if that works.

This is for the bitx 20 it goes to the base of transistor? Q2 and ground. Altering the gain at the 1st IF transistor. Is this the board you are refering to? I am not sure you can use that AGC board

This one ( http://1.bp.blogspot.com/-weRlvoq9Xos/U-yEV49cuhI/AAAAAAAABn4/Gsf3hvCpgJQ/s1600/AGC%2Bdetails%2BBW.jpg ) Jim? -- John - N0CTL - Fulltime RV in a 40' motorhome

Here is a power resistor I used in another dummy load. These could be an alternative if the ones specified for this project are hard to find. https://www.mouser.com/ProductDetail/605-RHXH1Q100R0F4 I

Did you mean this one? https://www.ebay.com/itm/LM386-Electret-Microphone-Power-Amplifier-Board-Gain-200-Times-DC-3-7V-12V-Pi-LB/153193602065?hash=item23ab0cdc11 wrote:

Raj, what are the spurs like when running finals at higher voltages. 24v has been suggested.

Better yet, repeatedly do both steps until no further adjustment is needed. I have no idea how the two different adjustments might affect each other with the firmware you are using.

I don't know what firmware you are using or what instructions you are following. Tuning for zero-beat makes sense to me when calibrating the si5351 reference oscillator so the rig is on the correct

After relay change my uBitx 4.3 is now capable for legal CW QSOs. So I did the next step and changed L5,L7 and L1 to 680 / 330 nH. The first test on SSB via dummyload and 20db extra attenuation direct

Merci, but no - what I am looking for is NOT in this .rar. Jim

All this when TX is off!

Raj, I will try this. Bill... tried that, but when keying the transmitter, I still hear the bumping of Raduino... even if the CW TONE line is grounded.

Hello Voici le fichier .rar 73 QRO F1BFU - Fr -- Gilles - F1BFU/FR

Thanks Art, I already have that file and the actual schematic with connections shown is NOT in that .rar.? There was another one that got posted somewhere that actually had the connections for IF-1

Jim Agc kit file Art N2AJO Sent: Monday, October 29, 2018 9:00 AM To: [email protected] Subject: Re: [BITX20] Sunil Lakhani's AGC board connections to uBITX #ubitx That's not the AGC board, that's the

That's not the AGC board, that's the front panel board to one of Sunil's cases.? The AGC board is a separate kit from them. Jim

Jim /g/BITX20/photo/6439/8?p=Name,,,20,1,0,0 Try This Art N2AJO

Anyone have the schematic that shows how to connect Sunil Lakhani's AGC board kit to the uBITX?? I found a diagram that had all the connections once, and like a dummy forgot to print or save it.?

Hi, I installed a small pot (10k) in series with the line into the audio channel from the Raduino. The trace I broke is on the top of uBitx mother board to the right of the Raduino socket (looking at

Try a 10K or 1K preset (center and one end) parallel with C252, this should work with 10K but if not try a 1K preset. Raj