开云体育

Very Nice! Are the sides open? ? If they are closed, ?how did you fasten them? ?A photo of the sides would be good. Irv, W4IWK

Very good. Is version 1.097 stable yet? Are you using it personally? David A Posthuma, WD8PUO 1 (616) 283-7703 Sent: Sunday, September 02, 2018 5:01 PM To: [email protected] Subject: Re: [BITX20]

It’s in version 1.097

Believe you can push the tune button and dial to setup? The deselect until you get to change key. The menu is still there. I am not sure but think you can change it via the screen using 1.097 Art

KD8CEC V.1.095 FEATURE REQUEST – RE: CW Settings. Overall, I love what you have done with version 1.095. However, I wish the CW settings could be managed better. It appears that the only way to

Mike: The 1.095 firmware screen reads “straight” for key setting, but when I go into the menu, I cannot find anywhere to change that setting. Nor is the screen label on the screen selectable to

Nice and simple. Why don’t you give us the OSHPark link and we can just order some of these instead of designing our own…? Sent: Sunday, September 2, 2018 3:07 PM To: [email protected] Subject: Re:

Received my version of an external LPF board from OSHPark. To second Jerry's comments, OSHPark has a very nice front end process. This board is 1.5in by 3in sized for T68 cores and 1206 caps to

You only need to load the Raduino firmware for BitX40. original sketch v1.01 with basic LSB functionality: https://github.com/afarhan/bitx40 improved sketch v1.28 with many extra features:

Thanks for doing this. The diagram is very informative (need this diagram for the uBITx too). You are correct but a BPF (not LPF) after the mixer is probably better since the mixer is where most of

Boom Box uBITx… Sent: Sunday, September 2, 2018 2:28 PM To: [email protected] Subject: [BITX20] Perspex Case Just couldn’t hide the beautiful electronics ? --- This email has been checked for

All, in preparing my talk to be held at the "UKW-Tagung" in Weinheim Germany next Saturday about my UBITX I prepared a level diagramme with some assumptions: the maximum powe rlevel at the input of a

I would think that Farhan should put a disclaimer on the hfsigs website stating that the ubitx does not meet some countries (i.e. USA) specifications for legal operation and that it will take a

Just couldn’t hide the beautiful electronics ?

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* D:DokumentWeinheim

I replaced the Arduino Nano and the SI clock chip and got the uBitx running. I then noticed a short on 2 data lines to the relays. I cleared the short, but after that the i2c bus always is sending

You need to load the Bitx40 firmware, as Allison mentioned. Only other issue is the uBitx has pins soldered in place so the Raduino can plug into the main board, the Bitx40 uses a 5 pin wire harness

Ok thank you, too now i am know this and i'm verry happy to know everything new from HAM and Radio technics. *I tried to set the BFO in the menu by display and the IRF510 (RVF2 + RFV3) current to

Tech Guy, I'm using mine for something different that Bitx40 though same idea, an Atlas210. You have to alter the code, I'm sure you know that. If you make OSC-0 and OSC1 both zero (0L) that shuts

Swap the sideband frequency settings or go into the code and swap the messages. Allison