开云体育

SolderSmoke Podcast #206 -- GQRP CONVENTION SPECIAL EDITION | | | | | | | | | | | SolderSmoke Podcast #206 -- GQRP CONVENTION SPECIAL EDITION Radio electronics blog. Homebrew ham radio. SolderSmoke

You have set the BFO on the wrong side of the filter. Re-align the BFO please. - f

I finally found your text. You are writing inside the quoted section and the web version only shows a blue rectangle with three dots...??on an other wise blank page.? Be careful of the Emailer as

Has anyone used a ubitx radino with a bitx 40? I ordered a bitx 40 before it came with a dds. Changing the IF setup in software? Thanks -John

It becomes a big deal when they hook up a uBitx to their KW linear. Especially if they goose up the mike gain to get enough drive. My primary concern is that any future version of the uBitx meet regs

Or they can ignore it all and just use the damned thing. I suspect that's what most users will do. I'd guess that the vast majority of uBitX buyers aren't even aware of the issues and those who are

If you're using the web interface, click on the three dots ... that will expose his post. For some reason groups.io isn't showing it, but I'm seeing his posts fine - I use email for this. Vince -

Jim, And? where is the comment or question?

Here are the changes to file ubitx_si5351bx.ino of Farhan's stock code? that are needed to hit 115mhz. With this change, the three available clocks can be set to any frequency between 514.5khz and

If it's any consolation, Jim, I saw your text in the post Dex is referring to. I guess he doesn't realize that you don't post at the top of the message, rather the bottom, old school style. Vince -

After finally getting around to spending some time with the new ubitx20 I discover that the ssb indications are reversed on the display and the stations are tuned from the wrong direction. Both side

That is a wonderful idea! Thanks. 73 Adam Goler, PhD Cell: (425) 985-8700 "Fear is the mind killer."

The plastic sheets used for campaign signs (in plentiful supply the day after an election) are great for prototyping many things.? A little duct tape to hold it all together and you are in business,

A small point but not all firmware uses the different voltage across resistors. rOn

I suppose that does depend on a person’s skill at executing the myriad of expert opinions opined on this group. I myself do this for a living so I’ve redesigned the entire radio. That’s one end

Hi Bill, Apologies for the delayed response. It has been a busy week. With regard to your photos, I think your breadboard set up is OK. The white wire and red wires go to the sides of the paddle

Charles, yes the RF shielding isn’t the greatest; I had considered using some aluminum tape, but then figured it’s made of cardboard. Really this is just a temporary box while I build something

What about RF Shielding and Grounding? Is that not an issue? All the best to you Charles T Dennis ________________________________ Sent: Sunday, September 2, 2018 6:42 AM To: [email protected] Subject:

Looks quite serviceable! At a slight increase in cost and pollution, I’m going for early American Home Depot plywood. Gordon

David Did you change the setting from ST to IA or IB in the menu? Mike ZL1AXG -- Mike Woods mhwoods@...