开云体育

I really like that look.? Where did you get that briefcase and how did you create the front face metal panel??? I am toying with the idea of a setup like that or maybe an ammo box setup where I

This <$1 50 mm 12V fan... https://www.ebay.com/itm/DC-12V-Black-50mm-80mm-120mm-Square-Plastic-Cooling-Fan-For-Computer-PC-Case/222690840881 ...fits nicely on the back panel of the Excelway case from

Thank you for the fast reply. I got to the next page of posts where My post was and read your post above about which one to buy. ?I promptly deleted my post, not promptly enough it seems. ?Thank you

Both looking great and worthy ideas no less. 73 Bill WA8VIH/4

now if I could just remember where I left my damn notebook... -- www.bitxmap.com ( http://www.bitxmap.com )

TNX Ashhar . . . Maybe include that in the new instructions?? hihi Love your work!!!! Best 73

TNX Bill and I think Vince did the same thing. I received some boards from China yesterday that I forgot I'd ordered. I had to go to Paypal to see what 2 of them were. Looked liked great boards, but I

Thanks for all the replies. I will do the raduino update as well as the mod to mute the LM386. Should fix the problem. Great to have all the support. Cheers -- John VK6JAH

Very nice build. I plan on doing the same thing. I wanted something that fit in a backpack. I even have room for a 12v 7AH battery in the case. Thank you for the inspiration. Marco - KG5PRT

Powering the uBITX down, reconnecting to MM and reading and decoding does not show the WSPR settings as I originally tried to write. I am using Windows 10. Just what is the Match Data box in MM

Here is my uBitx. The display is too bright and came out white. I use the RF gain, AF gain, tuning, band selector, Function and ANL controls at the moment. I reprogrammed the Raduino so that A7 reads

Here's my attempt at a 'transportable' uBitX. The box is a 'toy' briefcase and the display is mounted with a ribbon cable on the top surface. The gaps and perforations are for air flow ?as there is a

The S-meter and PO use pin A7. You will need relevant hardware mods to use the meter. Both functions can use the same pin since one only works on RX and the other only on TX. However this doesn’t

So far . . .

Don, I have this effect after installing the AGC board. I hadn't done the twisted pair on the links to the volume pot so I did that. It almost knocked out the problem on 40 but still very noticeable

Yes, please. Then un-jumper the header, leaving it open, and see if the feedback remains. Next step is to disconnect the S meter lead. Then short J1 to ground. If we can isolate the problem then we

Don - I'll try this - do you mean leave all the wires still plugged into the AGC board, but unplug the AGC board from the main PCB?? And should I then jumper the two outside pins to "restore" the RF

If you power cycle the arduino then read it with MM, are the fields still filled in?

The IRF510 can tolerate up to about 30V if the SWR is reasonable.? I've run the same pair at 28V for years.? Expect a lot more power and watch the heatsink temps.? More power more cooling required.

Hi Carl See here: http://ubitx.net/mod-tx-compression/ http://ubitx.net/2018/03/09/mic-compression-and-noise-gate-with-ssm2167-module/ http://ubitx.net/?s=SSM2167 Cheers.