开云体育

same here....nothing on the whole band. don

Nuttin but noisze here, and a lot of it! Anyone else on? -- John - WA2FZW

Its not a drop in.? The filter would likely be hard to find and costly or for a one off salvage from? an old junker commercial radio.? I think Kenwood radios used a 63mhz filter or maybe ICOM.? so

Another set of eyes on this, and I concur with Howard.? I didn't see anything obvious that would have caused damage to the Radunio/Nano where TX works and RX is not working. I would imagine that this

Is it only the cost of the higher frequency IF XTAL filter and the accompanying semiconductors of the driving chain that makes the route of first IF freq. elevation to 62MHz or higher not appealing?

Good, You want to look at 28mhz and what every power you get. IF the mic gain is low its not too bad (amplified mic or added preamp) if it high? it will be there. Not an issue on 80 through 20.

First do Q90 with a UHF part then 911/912.? I'm not sure of the 2N5179 not for power but for voltage as its a 15V part if memory serves.? I use it for wideband low power amps but at 12V max. With

OK. I will try to keep it simple. Lets take the example of Q10. It is not straight forward to calculate its operating point, because the bias voltage depends on the collector current, which is a

Thanks Howard for all your help. By shifting the connectors my first thought was that the transistors should not be affected, but who knows. Yes, I just have to go the hard way and measure as good as

Sorry you are having this problem. If you shifted the Raduino1 connector, and the transmitter is really working, I don't see how that can cause your problem since all the signals must be working for

Thanks Howard for the hint. But the result is just the same. I am afraid I destroyed some component (the raduino?)

Good question, But this can be a fruitful add-on to your existing display. But If there’s interest , I/we could look at a direct plug in module to replace the existing board, Pin-Pin compatible. Too

Does this replace the original display? rOn

Nextion displays , by default are touch screen , Serial Displays regards charudatt-vu2upx Sent: Sunday, June 3, 2018 6:00 PM To: [email protected] Subject: Re: [BITX20] Nextion Display I just wondered,

Hello Allen, It has its own IDE and commands are pretty simple to use , since everything is serial. Learn by examples and YouTube Tutorial regards charudatt-vu2upx Sent: Sunday, June 3, 2018 9:09 PM

Peter, I did join the group, but all that’s discussed is the use of this display in DMR use. Hope the interest spreads in other areas also. regards charudatt-vu2upx Sent: Sunday, June 3, 2018 11:08

Peter, this is a very interesting ?Facebook page. Thanks for posting it. kn4ud ? -- Allen ?Merrell

Since most of the circuits are bidirectional, and you can hear birdies, is still sounds like the antenna is not connecting to the receiver. Check relays K1 and K3 are not energized. Either one being

Al, many thanks for posting this. Wiring that up is the next step in my project and I was getting ready to look into this. You saved me the effort. I'm thinking of routing the hi level audio off the

No,?(a LW antenna). I have tested the transmitter (works), but the receiver doesn't work