开云体育

Order sent I need to get a BOM can't find one or do I pull it from the Manual? ? ?73 ? Now I need to get a bitx David ?N8DAH

L3 is fully isolated for DC by the three caps around it, so shorting L3 to C130A1 should not have done much. Make sure both wires of L3 are still soldered to the board or receive will be deaf and

Hi Bill, I’d like to take a board if you get a couple, 73s John VK2VOL

Hi Jack I think a little more clarification on the international order cost would be helpful. "4 boards go for the price of 1" That suggests that 2 or 3 boards could also go for the price of 1. If

As mentioned already please try v1.14.1 Please also make sure you're using the correct SI5351 library. It MUST be v2.01 (later versions are known for strong tuning clicks). If it doesn't work for you

Trying photo again...

Right, taken another look at the board and the good news is that I didn't reverse the polarity! There are no obvious solder bridges or damaged tracks etc either which is good, however I did notice

Its the VK3YE AGC circuit, available videos in 3 parts from youtube. https://www.youtube.com/watch?v=IQ5JEPRiPoM&t=263s BC548 diagram [image: Inline image 1] Sometimes its the simple things that trip

Do you have a picture of the schematic with the corrected transistor pinout? thanks Joe VE1BWV

there is only VFO, Cal. Button and Mic. connected in my Bitx40, I am only going to use it on LSB ! I have a lot of 7MHz CW Rigs from about 200mW to 750mW and there is a Regen set on workbench for CW (

if only i knew the beast this would unleash.... :-D - f

it was V1.14 since I have note noticed release of V 1.14.1

Didn't know 1.14.1 was released. So many emailed go flying by on this group. It's hard to keep up. I'm gonna try that because I downgraded to 1.13 because the ticking sound when it's just sitting

Anyone tried to put the raduino into a faraday enclosure like the old times ? 72's CX5AA

Hmm, surprising. The sketch provides more functions, but if they are not being used they can't generate extra noise or birdies. Did you use v1.14 or v1.14.1? There was indeed a small bug in 1.14 which

Hello all, Time for more fun. go to the web site below. My long time friend K9HWL sent this web site: https://www.cereproc.com/en/products/windows_sapi Once on site copy and paste this (or yours) *C

Hi Bruce, Please publish Your work/sources.I'm very Interested/impressed to see Your work.Thank You in advance! 73!

Hi all, Before couple of days I write mail that confirm the same thing. Old raduino source in my old homebrew rigs (I have 4 homebrew cw rigs with modded raduino and Si570, AD9851 and Si5351) , don't

Today I have tested some different Raduino Version for Tuning Clicks and that dammed 7.200MHz Birdie etc. let us start with V1.14 there is a lot of functions in it I do not need and to my big surprise

first, for psk31 (bpsk, which is what almost everybody uses), you don't have to flip the sideband. both sidebands work just as well (like they would for CW). The easiest way to flip sidebands is with