开云体育

OK Simon, What I had not mentioned is that the carrier balance pot needs to be re adjusted. Listen to the carrier leak in a near by Rx and adjust for a minimum or scope the output after removing the

Hi What is your serial number. It is written on the main board. Randy, K7AGE km4wii@...> wrote:

You will prpobably need something that can deliver about 1.5A at 12v well regulated. I dont think a wallwart would be good enough. I have used various power supplies with mine. 12v bench supply, 14.1v

To continue beating this horse unto death, we could use twenty-six FT37-43 cores to wind L1-L15 and T1-T11? Be gentle, I'm still just a cookbook technician.

I've been lurking for a while now, my Bitx40 should be here any day. It occurred to me today while driving, I don't recall seeing any discussion about power supply. Wall wart? Battery?

I just ordered mine. Reading the posts here is torture! ;-) wrote:

Hamfest not halfway. Stupid autocorrect

My bitx40 just arrived. Ordered 2/12 delivered 3/7.? Too bad there's a halfway this weekend. Maybe I'll get some build time Sunday afternoon. Wish me luck!

Hi Could you send a picture of your modification?

I suppose you are his spokesman? The BITX40 will inspire you to experiment. Modify it, mount it, tweak it, change it. Also stated; Raduino is a standard Arduino Nano He doesn't build these. That's

It would have been much more use just to say the core types and the amount of turns .... Job done ... Simple. Regards Marc ?'Gw0wvl'... Sent from Yahoo Mail on Android

I think these are useful: /g/BITX20/message/22955?p=Created,,,20,1,20,0::recentpostdate%2Fsticky,,,20,2,0,4438163 (

If there is a list being compiled, for future purchasing of an assembled version of the uBITX, please add me to it. ?kg4rul@... ( kg4rul@... )

The Inductance for L1 to L15 are shown and can be worked out from Calculators on the net, But there is no data on T1 to T10. Are they all the same? and if so, are they the same as the Bitx40? any info

Raj I cut the track beteween the wiper of r106 and r38 and confirmed the break with my multimeter. Then put the cap across that break.? The reference in my earlier post to "path to ground" was

The answer's just up thread a bit, mate. ?/g/BITX20/message/23001?p=Created,,,20,1,60,0::recentpostdate%2Fsticky,,,20,2,0,4438163 (

Harry, Should work on the iPad too. For PTT, the HTs that I was using both provided VOX. Here is an article about building a poor man's Signalink USB out of a cheapie USB sound card dongle.

Dear Ashhar, I have just created a pull request on your Github repository. So that you can easily review the changes I made. If you agree with the changes, please merge with your bitx40 master. So

I have added more structure/sections to the wiki. Please review/comment/contribute. Need short, complete write-up for each topical area. Can be as easy as expanding upon a post that you have already

Looks like the idea for using the BITx40 on digital modes is not as straightforward as I would have liked. I may order it just as an educational project - always had trouble with C, this might be the