If it is a continuos carrier the check for short of
blue wire. It should have 5V through
the 4.7K resistor.
Raj
At 29/07/2018, you wrote:
toggle quoted message
Show quoted text
Hello All
I have built my uBITX V3 into one of Sunil's [VU3SUA] metal boxs as per
instructions supplied.
I powered it on to test, and I see the raduino loads the software, but
then immediately it goes into CW transmit.
Well I was surprised, as I had taken note of the WARNING in section 3.3
"Wiring up the CW Key" and note that I indeed have the 4k7
pull-up resistor installed.
I have doubled checked all wiring, measured the resistor to make sure I
have the correct value, and cannot find anything wrong.
Has anyone else had a problem like his, and how did you fix it?
Anyone have good pointer to look at?
--
Kind Regards
Rodger - ZL1RAH
Raj vu2zap