开云体育

On Mon, Feb 19, 2024 at 10:20 AM, <vu3smz@...> wrote:

I have just installed the toolbox on my Sbitx v3, when runner the scanner it gives an error that telnet port not open, not sure hoe to do it need help , the toolbox is great tks.

Hello Mukund,

Page 11 of the manual?? describes how to connect.

I will break it down in easy steps..

1. Start sBitx and make sure it is receiving signals.
2. Open the Scanner application.
3. Press Main from the top menu
4. Press Connect
5. Set the parameters for your scanning range and press Start.

It's important to understand that the sBitx Scanner app can operate with the sBitx transceiver without needing an internet connection.

However, to use the Windows application, your computer must be connected to a network (via WiFi or Ethernet) that is also connected to the sBitx transceiver. Ensure that your sBitx transceiver has WiFi or Ethernet enabled for this setup. To verify the communication between your sBitx transceiver and computer, you can perform a simple test by executing the following steps on your Windows computer:

?

1. Press and hold the Windows key, then press 'R'.
2. Enter "cmd" and press enter.
3. Type "ping sbitx.local" and press enter.

If you receive a response back like this, then you are able to connect to the sBitx transceiver and try the steps above.?


-JJ