开云体育

Oliver I down loaded latest version on Get Hub and updated libraries as instructed. I used IDE 2.3.6 (couldn't find .5) All compiled fine. I reset memory on Teeny. Uploaded no errors. On boot up

Thanks Andy! Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner - Operator Big Signal Ranch – K9ZC Staunton, Illinois Owner – Operator Villa

Also posted to SoftwareControlledHamRadio. I have created a spreadsheet for you to express interest in boards and kits from Bill, K9HZ.? There are currently no prices on the spreadsheet as these

I do have part of my new system for invoicing for boards and kits up and running. Invoices for will come to you from Paypal and have the email address sales@...

For those of you in the UK/EU. Andy Rutter, G8HCK, has graciously agreed to distribute T41/ K9HZ/ K9HZ-KI3P boards and kits there. I'll attempt to ship him a load of stuff and he will make

I used 2.3.6 IDE I think results look good: Memory Usage on Teensy 4.1: FLASH: code:312604, data:132408, headers:8612 ? free for files:7672840 RAM1: variables:194688, code:288904, padding:6008 ?

I ran across something that I need to share. I bought a two-pack of audio transformers on Amazon that work very well for the cost. Works great to break ground-loop issues, hum, etc. Cheap too. and

I used my V10 (4sq kit) for many contacts before selling to finance V11 build. Nothing bad about that version, 10 and 6 were problematic but there are fixes for those bands. I also used Dr. Bill's PA

All: Recent there was a negative post about the V11 boards and the T41 from 4SQRP. I got this private email from Neville Marr, ZL2BNE, who has been following the T41 from its inception. He has a T41

Hi John Strange because at the end of the process, a window open to save the file. Had you already installed SCAD before? , it is mandatory. I think, now you have it installed, the "EXE" will work.

Good...glad it helped. Jack, W8TEE

Appreciate the help, Jack. ON my PC I did what you suggest, partially at least. I removed the old IDE version and now IDE 2.3.5 compiles OK. Glenn

The code I wrote to measure SWR from the forward and reflected powers is

Thanks for the clarification of your addressing method, Bill. It resolves the issue for me that was created by Paypal's new insistence on my using only Australian shipping addresses.

Alex, I tried https://github.com/kirberich/gerber_to_scad , and though it took me a lot of time to figure how to set up the environment, it worked. Afterwards, to convert the scad output file to STL,

Dave… the code for the analog SWR metering is not there. The code for the I2C stuff is… BUT with this said, its not a hard thing to do. A12 is Forward power and A13 is Reflected at the teensy…

I shared an amazon link earlier to a board that should work. I don't recall exactly where I bought the particular board I have on hand and can't find a purchase record since it was many years ago.

Tim I have not built this up as yet.? You need to ask Oliver which board that he used.? If you look at the Pix that Oliver attached and count the pins it is a 38 pin ESP32 Development board [I think

Thanks Alex!!

Thanks Alain!!!