开云体育

Hi Harry, Thanks for the note. I just checked my records and I sold a total of 218 full sets of V10/V11 boards (plus odds and ends of full sets). But that was two plus years ago. I may still

Thought putting together a simple schematic and some notes would be easy.? It involved way more than I expected. Attached is a zip file of a package of information on how to construct a test stand

I came across the attenuator problem chasing another problem ... probably didn't need to change U21 and U12 ... Thank you all for your help. Tom

Found issue not sure of cure! The Mic 1/8 IN socket is not chassis grounded on grounded to Mic Ground on Audio Hat. So PTT on mic panel jack is not chassis ground, and if you connect the Mic and PTT

Except that modules that have not been released yet are not part of the connection sheets. Ask though if you are interested. The big ones will be the Tuner, the 100W module, and the VHF-UHF

Ah ok that’s for the clarification. I had remembered that process working. Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner - Operator Big Signal

To be clear: the software is there to control the output attenuator. There was a bug when trying to use the menu to do so, but this does not affect any of the calibration routines.

ALL was fine until I tried SSB TX. PTT will not go into TX, CW keys up just fine. I went directly to 1/8 input socket and tried grounding PTT there and still no luck. Tim W4YN

??

Hi David:You might also want to join our site, too. (/g/SoftwareControlledHamRadio) There is a boatload of information there plus a lot of stuff in the Wiki and Files sections that

I can control output power. Am not near my T41 so can’t test voltages dave, n3ds

Ok so the software wasn’t there to adjust the TX attenuator. How the heck did Al calibrate the output power then? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ

When RX_BPF is LOW/FALSE/0, S21 between J23 and J18 (assuming receive is bridged to transmit in the TR switch) should be low, meaning less than -45 dB. That's what is shown in the plot on the

Added the following at line 748 of [MenuProc.cpp](https://github.com/KI3P/SDTVer066-9/commit/d6351b5d936f2514e001ad4b337e39e10358ed75): SetRF_OutAtten(adjuster); The version on GitHub should be able

*** So - you did this measurement with RX_BPF_SEL = False, right? -Jerry, KF6VB

Music to my ears! Thanks Bill! David

I'm away from my radio at the moment. Can someone with a working radio confirm that this affects them too? Will take a look at the code tonight and see if I can find anything obvious.

Hi David! Welcome aboard! I shipped your boards today so you can get started in about 3 days! Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ Owner -

Hi everyone. Just getting started with this amazing group and I wanted to write a quick note of introduction. I have long been a kit builder and tinkerer with electronics.? My first real success was

Good question… the TX attenuator should work the same way… so either there is a bug in the software… or there is a problem with the MCP23017. Since the RX side works I think its probably a bug