开云体育

  1. 7x12MiniLathe
  2. Topics

Remover for LMS MT2 QCTP holder 250-005

 

That is a new one.
I have place to put morse drift key on Aloris?
?
Thank you?
Dave?
?
On Thu, Aug 22, 2024 at 10:36 AM, Bruce J wrote:

If you have more mt2 tools than mt2 QCTP holders...

On Aug 22, 2024, at 8:44?AM, davesmith1800 via groups.io <davesmith1@...> wrote:
I think miss something?
Why do need remove it?
?
Dave?

--?
Bruce Johnson

The less a man knows about how sausages and laws are made, the easier it is to steal his vote and give him botulism.
 

开云体育

If you have more mt2 tools than mt2 QCTP holders...

On Aug 22, 2024, at 8:44?AM, davesmith1800 via groups.io <davesmith1@...> wrote:

I think miss something?
Why do need remove it?
?
Dave?

--?
Bruce Johnson

The less a man knows about how sausages and laws are made, the easier it is to steal his vote and give him botulism.

 

I think miss something?
Why do need remove it?
?
Dave?
 

Yea - used one of those too, until I made this.? So much quicker to just drop it in and pop the arbor out...

On 8/21/2024 9:59 AM, paul mcclintic via groups.io wrote:
You could also use a regular 2 jaw puller with a short piece of rod. Paul M
 

You could also use a regular 2 jaw puller with a short piece of rod. Paul M
 

Tried that... they seemed a bit? flimsy for some of the mt2 arbors I had. I even mod'ed them to get rid of the thin section.

Plus like all gear pullers they're a bit of a pain to deal with. With this you just drop it in and it pops it out.? LMS should sell something like this for that QCTP MT2 holder.

?I recall when I did the 2" riser for the solid column mill? and sent photos to Chris - .? He then started selling them.

Also when I did the pin assembly to hold the spindle (see this: ) he ended up making a similar thing - tho it had an interlock circuit.

I've sent him a few things that he ended up selling.? Lots of mods for LMS lathes and mills on my swarf page:

I use my tools for my job. Any mod that can make it easier, more accurate, and faster I'll do...

On 8/20/2024 8:20 PM, Roy via groups.io wrote:
Another way is to use a faucet handle puller, which saves having another single use tool.

< >

Yuck! Here's the tiny URL version:

< >

Roy
 

Another way is to use a faucet handle puller, which saves having another single use tool.
?
?< >
?
Yuck! Here's the tiny URL version:
?
?< >
?
Roy
?
 

1 - 8 of 8