开云体育

  1. 7x12MiniLathe
  2. Topics

Mini 4 jaw chuck

 

Just a new 4 jaw chuck for rotary table 48mm dia.
?
Nice size for small parts.?
It is not turning just light work on the 3" rotary table.?
?
Dave

 

How is that chuck mounted on your RT?? The 3-jaw I got for mine has a "skirt" around its base with 4 screw holes.? They match the 4 T-nut slots on the top of the RT.
 

It has two tap holes and has thread mount 14 mm too.?
?
I have 2?" aluminum bar stock I going to cut thick washer about ?"thick.?
They do make mount for the chuck mount to a rotary table.?
?
The chuck is nice for small parts.
?
Dave?
?
On Sun, Jan 19, 2025 at 07:24 AM, Mark Kimball wrote:

How is that chuck mounted on your RT?? The 3-jaw I got for mine has a "skirt" around its base with 4 screw holes.? They match the 4 T-nut slots on the top of the RT.
 

Off the internet of backs for rotary tables
 

Backplate for chuck?
Note ?NC tape hole for hold down? parts in chuck .
Handy to one in center.?
?
Dave
?
?
?
On Sun, Jan 19, 2025 at 07:24 AM, Mark Kimball wrote:

How is that chuck mounted on your RT?? The 3-jaw I got for mine has a "skirt" around its base with 4 screw holes.? They match the 4 T-nut slots on the top of the RT.

1 - 5 of 5