开云体育

  1. 7x12MiniLathe
  2. Topics

Milling Attachment on mini lathe

 

I am put a Milling Attachment on mini lathe that post photos there milling attachment.?
?I have a new copy of Tiag type milling attachment. From Walmart.? Look how did on Littlemachineshop.com.? They made it offset why?
?
I have this since Nov 2023 from Amazon and just getting around to installing on the lathe. I have look putting on compound but that is unstable so going to put on the cross slide like others have done on internet but it always great even if bad.?
?
Dave?
?
FYI I finished rotary table.?
Nice light easy to use and setup.
?
?
?
?
?
?
e
 

开云体育

Ya can smooth that thing up some by installing a thrust bearing & washers under the dial .

animal

On 2/13/25 4:21 PM, davesmith1800 wrote:

I am put a Milling Attachment on mini lathe that post photos there milling attachment.?
?I have a new copy of Tiag type milling attachment. From Walmart.? Look how did on Littlemachineshop.com.? They made it offset why?
?
I have this since Nov 2023 from Amazon and just getting around to installing on the lathe. I have look putting on compound but that is unstable so going to put on the cross slide like others have done on internet but it always great even if bad.?
?
Dave?
?
FYI I finished rotary table.?
Nice light easy to use and setup.
?
?
?
?
?
?
e

Attachments:
 

Mill ATTACHMENT on workbench.?
?
Dave

 

Great idea?
?
I am planing that?
I have? aluminum bar stock and bearings planing on putting a large dial on at same time.? The new cross feed screw is exta long so I can adjust for bearings.??
?
Dave?
?
?
?
?

1 - 4 of 4