开云体育

I think there are two pulleys in the center, one is connected to the shaft, one is loose on the shaft. A flat belt would be shifted from one to the other to either drive the shaft or not. Brian

Presuming it’s the big green wheel you want to drive, replace the black stone on the other side with a pulley or a direct connection to the shaft. I have a similar arbor at home, although it does

Generally, you never want to machine wood on metal lathes and mills.? This is the "common" advice.? It is true that there is a rather high risk of rust as wood, unlike metal chips, contains

here? the image

A- I ahve this? vintage? setup I put some? grinder? disk? put? tooo? large? for? my? normal? use I? put? al x6? to male a kind? of? wheel advise? is? it? good? or? a? bad?

I have turned wood and Trex on my mini lathe. I have also machined wood and Trex on my mini mill. You are only limited by your imagination. Regards, John Mattis (retired mechanical

Messy but certainly doable. Just consider you won't be getting a nice finish from machining. If that is required, then some sanding will be in order and there goes, at least, some of your desired

Much to the horror of many, I have used both my mini-lathe & mini-mill to cut wood. Works fine. The only problem you’ll have is the sawdust sticks to the oil making it a bit hard to clean

Nice work @johannes!? I had built something similar to your lathe/mill attachment, but I see some details in your mod that I'm going to incorporate into mine.? I like the idea of the plinth block.?

?Dear Gentlemen, 1. If you feel this is too far off the topics generally covered, then may I ask you to simply delete it. I do not want to generate a lot of wasted time and effort on is/is not

The first thing tested was my lathe bedways . I forgot to say the reason for small ball so test thiner materials. But out looking for materials a large ball is harder to lose. It happens a lot. *So

*Here is one on Hardness tester* *I like because leave no marks on new parts.* *Shows how built* *This Closeup of the scale .*

My picture disappeared someplace, so I send it again. [cid:b04419f9-9b17-4875-9e75-dc6f626edeed] /johannes Mexico

After some hours setting up the equipment , ready to do the new cutting with leadscrew, (Thanks to Roy,) I did something XXXXXXX Ok, so it is to be a lathe operator. However, I tested it on

Great idea I am planing that I have? aluminum bar stock and bearings planing on putting a large dial on at same time.? The new cross feed screw is exta long so I can adjust for bearings. Dave

*Mill ATTACHMENT on workbench.* *Dave*

Ya can smooth that thing up some by installing a thrust bearing & washers under the dial . animal

*I am put a Milling Attachment on mini lathe that post photos there milling attachment.* *I have a new copy of Tiag type milling attachment. From Walmart.? Look how did on Littlemachineshop.com.?

That was my instant thought as well. Something like this: https://www.homemadetools.net/forum/%5Bmetal-lathe%5D-indexing-plate-cranck-41391 It won’t work as a crank AND dividing head for your use

Yes Ellis I have made many disk with holes, however they are not precise enough. So now I have 1502 x 2 steps to help me. 1/2 mm is also a step. Johannes Lavoll.