Re: Cutting with rotating cutter
开云体育
After some hours setting?up the equipment , ready to do the new cutting with leadscrew, (Thanks to Roy,)? I did? something
XXXXXXX
Ok, so it is to be a lathe operator.
However, I tested it on something different , and I really liked the Leadscrew manual feeding.
I have made many disks with holes , many different setups,? and every time I think I have done the best.
Therefor is this lathe group being so interesting, a lot of new?ideas show up.
I needed to make a ratchet, 10 deg undercut, 60 teeth, so I first made the dividing disk,120 holes, in the lathe.
Moved it over to the Mill and did the job.?
(just remember to do the cutting on the correct side !!)
The picture shows the setup.
Johannes
Mexico
?
From: [email protected] <[email protected]> on behalf of Bruce J via groups.io <bruce.desertrat@...>
Sent: Thursday, February 13, 2025 14:27 To: [email protected] <[email protected]> Subject: Re: [7x12MiniLathe] Cutting with rotating cutter ?
That was my instant thought as well. Something like this:?
It won’t work as a crank AND dividing head for your use case, but for the times you need to crank the lathe by hand (like when making a large thread or worm gear ) ?it will work better than trying to get enough torque to do it with the lathe motor.
Christophe has a bunch of really elegant tools and builds.
--?
Bruce Johnson The less a man knows about how sausages and laws are made, the easier it is to steal his vote and give him botulism. |
Johannes
