Re: Troubleshooting Dead unit
|
That makes me feel better for my experience of thinking my lathe was dead - only to realize I had activated the emergency shut-off switch.
On Tuesday, October 29, 2024 at 07:46:58 PM PDT, Richard Ferguson via groups.io <richardferguson3.14@...> wrote:
I want to thank everyone for their suggestions, which seemed particularly good.? I was able to print out the schematic, thanks.
?
I started trying to measure voltage on the control board.? Nothing.? ?I could not even see voltage on the AC line......? That is when I checked, and found that the extension cord that the lathe was plugged into had become unplugged somehow.? I had been using that extension cord to power a bandsaw earlier in the day, so I assumed that it was still plugged in.? An embarrassingly simple solution.? ?I know perfectly well that when something is not working, I should first check power, AC or battery.
?
Thanks to all,
Richard
|
