开云体育

Hi,
I'm new to the list, having acquired an Enco 4x6 band saw on Sunday.
It's in pretty good shape but the motor needs new bearings. The end
caps (bells ?) have been removed but the shaft, front bearing and
bell are stuck together. I'd appreciate any advice on how to get
these items apart without damaging the bell. The assembly is being
treated with liberal amounts of kroil while I wait for advice.

--- In 4x6bandsaw@y..., "makull2002" <makull1@a...> wrote:

Hi,
I'm new to the list, having acquired an Enco 4x6 band saw on

Sunday.

It's in pretty good shape but the motor needs new bearings. The

end

caps (bells ?) have been removed but the shaft, front bearing and
bell are stuck together. I'd appreciate any advice on how to get
these items apart without damaging the bell. The assembly is being
treated with liberal amounts of kroil while I wait for advice.

Got them apart by supporting the rim on two sides of the bell
housing, applying a little heat and one sharp rap on the end of the
shaft with a plastic faced hammer. Used a puller to remove the
bearing from the shaft.