From: [email protected] [mailto:[email protected]] On Behalf Of Joe Blount
Sent: Tuesday, April 28, 2020 10:08 AM
To: [email protected]
Subject: [ExternalEmail] Re: [4x6bandsaw] Rong Fu Industrial Introduction

?

re: "Any other ideas?"

I think a popular option would be a low cost hydraulic downfeed that would bolt up without modifications to saw, or only required simple modifications.? If they wanted to sell accessories direct, either Amazon or Ebay would be a fine choice.

?

-Joe

?

Hi.?

Welcome to the group. This is a community of users. We probably aren't going to buy direct from the manufacturer in quantity.?

I'm quite impressed RongFu has reached out to this group of enthusiasts.?

?

Fellow members;?What would you have liked with your bandsaw if buying again?

?

Vertical cutting: I would like a better solution for vertical cutting position eg: a small built in plate for small cuts, and a larger one that is easily clipped on to the smaller plate (easy enough to make, but would be a nice accessory).?

?

Blade alignment: Better instructions or some sort of set up tool to enable the blade to cut straight.?

?

Any other ideas??

Melo

?

?

CONFIDENTIALITY NOTICE: This e-mail and any files transmitted with it are intended solely for the use of the individual or entity to whom they are addressed and may contain confidential and privileged information protected by law. If you received this e-mail in error, any review, use, dissemination, distribution, or copying of the e-mail is strictly prohibited. Please notify the sender immediately by return e-mail and delete all copies from your system.