开云体育

I recently purchased a used 4x6 bandsaw. Its missing a few parts,
including the V-belt and both pulleys.

I was hoping someone might be willing to measure the diameter of each
of the 3 steps on each of the pulleys on their saw. The size of the V-
belt would also be handy.

TJ, Perth, Australia

Here you go, T.J.,

Driving pulley (motor);
(measured on O.D. of step)
1.884 inches
2.223 inches
2.597 inches

Driven pulley (worm shaft);
(measured on O.D. of step)
2.164 inches
2.912 inches
3.701 inches

Above measurements should be very close, I measured them with a dial
caliper.

(note: the largest diameter of the driven pulley is next to the motor.

Belt;

O.D. 23.5 inches
I.D. 21.25 inches

Above measurements approximate, measured from a piece of rope, that
transferred the length from the belt.

Belt identification;

Gates (brand) Powerated 6823
First Rope (brand) A-22

Hope this helps! (down under) 8-)

Leo (pearland, texas)

--- In 4x6bandsaw@y..., dswr@w... wrote:

Here you go, T.J.,

Wow, talk about fast. Many thanks.

TJ

Uh... That should be largest diameter of DRIVING pulley is next to
motor. Sorry! 8-(

Leo (still in pearland)